Inovonics EN1262 Bedienungsanleitung PDF herunterladen

1.23.14 05469E © Inovonics, 2014 - www.inovonics.com

EN1262 EchoStream® Passive Infrared Motion

Detector

Installation and Operation Manual

1 Overview

The EN1262 is a low-current motion detector highly sensitive to moving

heat (infrared radiation) sources.

1.1 Inovonics Contact Information

If you have any problems with this procedure, contact Inovonics technical

services:

• E-mail: [email protected]

• Phone: (800) 782-2709; (303) 939-9336

1.2 What’s in the Carton

• One Duracell DL123A 3.0V battery

• Two selection jumpers

• Two mounting drywall anchors

• Two mounting screws

• Two housing screws

• One tamper wall anchor

• One tamper rivet

1.3 Passive Infrared Motion Detector Internal

Components

Figure 1 EN1262 Components

2 Installation and Startup

2.1 Installation Notes

• These products are designed to be maintained by professional

security technicians

• Products are tested for indoor use

• All products should be manually tested weekly

2.2 Mount the Housing

1. Insert a small flat-blade screwdriver at the tab on the bottom of the unit.

The screwdriver will enter the slot at about a 45° angle. Press

downward on the handle of the screwdriver until the latch holding the

cover to the housing base releases.

Figure 2 Open the housing

2. Pull the circuit board attachment latch and lift the circuit board out of the

housing.

Figure 3 Circuit board attachment latch

3. As desired install the wall tamper rivet.

Note: Wall tamper installation is required for BSI Class VI.

a. Use a 3/16” (4.8mm) bit to drill out the tamper rivet hole index.

b. Install the tamper wall anchor in the wall where you will be mounting

the motion detector’s tamper rivet.

c. Use a hammer to tap a rivet into place in the tamper wall anchor.

Figure 4 Mounting hole indices

A Wall tamper

selection pins

B Housing tamper

switch

C Frequency band

selection pin

D Reset button

A Tamper rivet index B Corner mount index C Wall mount index

Circuit board

attachment

latch

1 2 3

Inhaltsverzeichnis

Seite 1 - Detector

1.23.14 05469E © Inovonics, 2014 - www.inovonics.comEN1262 EchoStream® Passive Infrared Motion DetectorInstallation and Operation Manual1 OverviewThe

Seite 2 - 5 Specifications

1.23.14 05469E © Inovonics, 2014 - www.inovonics.com 24. Mount the housing, using either the three wall-mount holes or the four corner-mount holes.a.

Seite 3 - 8 Warranty and Disclaimer

1.23.14 05469E © Inovonics, 2014 - www.inovonics.com 3• Connect the equipment into an outlet on a circuit different from that to which the receiver i

Kommentare zu diesen Handbüchern

Keine Kommentare

Inovonics EN1262 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sensoren Inovonics EN1262 herunter. Inovonics EN1262 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Inovonics EN1262